Related Products

HOME > Products > ADSS/OPGW Fitting > Communications > Down Lead Clamp > Down Lead Clamp for Pole

Product Name: Down Lead Clamp for Pole

Product Number: 013

Product Details

Product Instruction:

Intended to fix ADSS and OPGW on pole, applied to different cable diameters, metal-type for OPGW, rubber-type for ADSS, two kinds for pole and for tower, easy, quick and reliable to install, with a large range to regulate.

 

Function:

Intended to fix cable when down-lead or jump-joint, one cable of 1.5-2.0m for one set

 

Parameter:

Configure model by cable and pole diameter.

 

Installation of Down Lead Clamp for Pole

 

 

 

  

 Picture of Down Lead Clamp for Pole installation steps, product functions and applications

     Rubber Down-Lead Clamp for Pole                                                      Metal Down-Lead Clamp for Pole 

Components: stainless steel strip, slide block, rubber clamp, washer 

 

 Installation Steps

  Picture of Down Lead Clamp for Pole installation steps, product functions and applications

1. Measure out the pole perimeter at installation position with tape line, and mark it out;

 

2.   According to perimeter L, measure out a length of 55mm on stainless steel strip, and mark it out;

  Picture of Down Lead Clamp for Pole installation steps, product functions and applications

3.   Take off slide block 1, pull the stainless steel strip through non-slope side of slide block 1;

  Picture of Down Lead Clamp for Pole installation steps, product functions and applications

4.   After pull through slide block 1, bend off the stainless steel strip at the marking place;

  Picture of Down Lead Clamp for Pole installation steps, product functions and applications

5.   Bend the stainless steel strip into an same angle as the same with block 1 slope;

  Picture of Down Lead Clamp for Pole installation steps, product functions and applications

6.   Insert bolt and screw up nut;

  Picture of Down Lead Clamp for Pole installation steps, product functions and applications

7.   Adjust the cable’s down-lead position, screw up;

  Picture of Down Lead Clamp for Pole installation steps, product functions and applications

8.   Install the parallel groove clamp and rubber clamp, and then set cable into them, screw nut up.

Installation is over.

 

 

 

Instructions: 

 1.   In moving and installation, the pole down-lead clamp shall be avoided from extrusion severe impact, and deformation;

 2.   As matching parts, the stainless steel strip shall not be changed randomly, shan't be used repeatedly, it may be disassembled and reassembled only once in installation which is permanent installation;

 3.   If in doubt, please contact us.

Facebook Twitter Youtube
Copyright © 2011 www.opgwfitting.com All Rights Reserved.
Powered by SEO | Fiber Optic Cable